Products Catalog: Intelligent wireless roof detector 86 - Shenzhen Autosecu Technology Co., Ltd

Products Catalog: Intelligent wireless roof detector 86

(Product Photo)

Origin:

China

Price:

FOB Shenzhen USD17.20

Payment Method:

Telegraphic Transfer (T/T)

Pack. & Delivery:

carton

Specification:

Despriction:

Adopting advanced digital signal processing technology, Compounding of high precision passive infrared detector and logical digital circuit design, feature intelligent power save, auto- tamperature compensation, low battery alarm and so on. It emits wireless digital signal to start the control panel for alarm through detecting human being body infrared heat. Nice looking, Reliable and fine quality.It can be compatible with many other control panel.

FUNCTION
1. Tamper switch: it will send alarm signal if cover is disassembled
2. Preset coding with the control panel: Switch the protection zone to “ ON” , press the
tamper switch and send wireless signal, the control panel sounds, it means that coding is completed matched.( refer to the coding program of control panel operation instruction and relative detector)
3. Low battery alarm: when battery is low voltage, the human being body moving, LED flashes five times. In static environment, it is not activated.
4. Coding address: preset by manufacture or by user.
5.Protected time choosing: 3 seconds or 30 seconds, it is preset by playing pins.
6. Compatible with many control panel.
( 3) SPECIFICATION
Power supply: 9VDC Li-ion & manganese battery 500mAh
Working current: static < 30µ A; alarm 150 m
( wide area without interfere)
Detecting range: high 2.4m from ground, covered diameter: 7.3m, high 4.5m, covered diameter: 9mWorking condition: working tamperature: -10º C~ 55º C
Product size: ¦ 96* 25mm
( 4) INSTALLATION.
1, Installing guide
Open the cover, connect the battery, than the detector starts to work.
Press tamper switch to transmit the signal to match coding of the control panel Close the cover, when installing it, please learn the following diagram.
When the power is on, the LED flashes for about two seconds, the detector will continues to delay for about three seconds or thirty seconds ( it depends on protecting time choosing) , than it enters the activate situation. If intruder enter protection area.The detector immediately sends out wireless alarm signal.
2. Usage
Walk test: to set the protecting time choosing to 3 seconds by playing pin, simulated as intruder go into the protection area, the LED flashes for about 2 seconds, the detector sends out the wireless signal, meanwhile, the control panel should receive the signal. After walk test, it tested well, please set the protecting time choosing to 30 seconds so as to start to work.
Note: When setting the protecting time, please shut off battery power and press tamper switch once.
( 5) CAUTION
Install the detector to the proper place where intruder must enter.
Do not face the detector to any area where window, lamp-house, heat thing and so on.
It is used for indoor, not for outdoor.
When installing, do not drop down or hit the detector so to avoid the internal infrared sensor.Do not touch the sensor lens so to avoid the detecting distance and sensitivity.
Have termly walk test

lily220860@yahoo.cn

Your inquiry will be recorded in "Member Trade Mail".

Recommend to your friends